The Pearl Girl

 

 

 

 

 

You will need the following

 

2 strings (14)  Fimo Balls 14mm  – Red and White Stripe

2 packets (13)  8mm Diamante Rondelle – Black Plated

1 x ‘S’ Hook Clasp – Silver Plated

1 x Bracelet Memory Wire

 

You will also need

 

1 pair of round nose pliers

1 pair of chain nose pliers

1 pair side cutter pliers

 

Instructions

 

1.       Measure the wrist that the bracelet is to fit on.

2.       Cut the memory wire using the side cutter pliers to the desired length - make sure you leave some spare at each end to make the loops for the fastener.  Also take into account the length of the ‘S’ hook clasp in this measurement.

3.       Start with the memory wire and make a loop on one end of the memory wire using the round nose pliers - large enough to fit the ‘S’ hook clasp through it.

Put the memory wire into the pliers and bend the wire around the jaws, roll the wrist until the loop is complete.  Please note that memory wire can be quite tough so a little strength may be required.

            

4.       Onto the opposite end of the memory wire start to thread the beads on.  Start a Fimo ball, then a diamante rondelle, then a Fimo ball again.  Carry threading the beads on in this way until the desired length is reached.  Make sure to leave enough room at the end to make another loop, large enough to fit the ‘S’ hook clasp through so as to secure it to your wrist.

5.       Make another loop to secure the beads onto the memory wire using the round nose pliers (as stated above), again, make this loop large enough to fit the ‘S’ hook clasp through.

6.       Put the ‘S’ hook clasp onto the loop that was made first.

 

Now it’s finished, all your friends will want one too!!!!